Glad to see I'm not the only old phart left around here :)
I actually just replaced a 100Gb WD IDE drive in my photo machine that has bearing whine that comes and goes...sounds almost like the start of a head crash (buzzy whine that comes and goes), but definitely bearing. The drive is going on 9 years old, which for any hard drive, is a VERY old one...I've seen most drives last on average 6 years on 24/7 use.
I would strongly recommend staying well away from Seagate and Maxtor drives. Seagate now owns Maxtor, and I have had nothing but bad times with Maxtor products. Seagate was a good brand way back in the day, but their marriage with Maxtor makes me nervous about their products now, especially considering the aforementioned 7200.10 series drives.
Stick with Western Digital...you can't go wrong.
Mark
----- Original Message -----
From: G. Armour Van Horn
To: artshow_photo@yahoogroups.com
Sent: Friday, December 17, 2010 2:43 PM
Subject: Re: [artshow_photo] 24" IMAC hard drive replacement
That's actually a cure for "stiction", a phenomenon in which the heads
actually stuck to the face of the disk platters. I don't think I've seen
a case of stiction or bearing failure in a hard drive for fifteen years.
Desktop drives are all made with "non contact" bearings, it's nearly
impossible for them to fail. The size of the heads is so small these
days that stiction doesn't happen either, although it was a very real
issue in the days of 5-20MB drives.
Yes, I'm old enough to have actually had a 5MB disk with 14" platters,
and used an 80MB 14" drive for a couple of years. That one weighed 95
pounds, and the cables to connect it to the computer weighed five more.
Those drives had the advantage that you could always just open the top
of the drive and move the head by hand if it got stuck, as opposed 5.25"
drives that tended to be sealed.
Van
On 17/12/2010 11:23 AM, Mark Mattson wrote:
>
> One old technician trick to add to this, if you have a spindle bearing
> problem (where the drive doesn't spin up, or spins up very slowly):
>
> Place the failed drive into a ziploc bag, close it up, and put it in
> the freezer for 24 hours. When you take it out, open the end of the
> bag, and plug in the data and power cables...but leave to drive in the
> bag, to keep condensation minimized as much as possible.
>
> If your trouble is a cranky spindle bearing, freezing the drive may
> give you enough time to get data off of it due to the bearing
> shrinking and freeing itself up for a time.
>
> I've used this many times to save data on my personal drives and those
> of others when the bearings are the culprit.
>
> Mark
>
--
----------------------------------------------------------
Sign up now for Quotes of the Day, a handful of quotations
on a theme delivered every morning.
Enlightenment! Daily, for free!
mailto:twisted@whidbey.com?subject=Subscribe_QOTD
For photography, web design, hosting, and maintenance,
visit Van's home page: http://www.domainvanhorn.com/van/
----------------------------------------------------------
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]
http://artshowphoto.com/support.htm
PLEASE READ....PLEASE TRIM POSTS!!! Keep quoted material short.
Repeat or create accurate subject lines.
If you want to advertise services related to art shows or photography, either in a forum post or on the resource web site, please contact the forum owner for permission.
Resource web site at
http://ArtShowPhoto.com
0 comments:
Post a Comment